Garmin GPSMAP 182 Owner's Manual

Also see for GPSMAP 182C: Owner's manual Declaration of conformity Declaration of conformity Specifications

Garmin GPSMAP 182 Owner's Manual Manual pdf 15 page image

5Getting StartedInitializing the ReceiverTo graphically initialize the GPSMAP 182/182C/232:1. Press the MENU key twice for the Main Menu. Press Up or Down on the ARROW KEYPAD untilthe ‘GPS’ tab is highlighted, then press the MENU key once.2. Using the ARROW KEYPAD, highlight ‘Initialize Position’ and press ENTER/MARK to initializethe receiver from the map. The Initialize Position Page will appear, prompting you to select yourapproximate location with the map cursor.3. Use the ARROW KEYPAD to move the map cursor and point to your approximate location within200 miles. If you have difficulty identifying your position, press and release the IN key to see thenext lower map scale.4. Once you have determined your approximate location on the map, press the ENTER/MARK key.This does not “calibrate”the unit in any way, but rather helps to speed up the initialsatellite acquisition. If the unit displays “Ready (2D) or (3D )”during this process, it isnot necessary to initialize the unit.The GPSMAP 182/182C/232 will now begin searching for the appropriate satellites for your regionand should acquire a fix within a few minutes. When viewing the ‘GPS’ tab on the Main Menu, a signalstrength bar for each satellite in view will appear on the bottom of the page, with the appropriate satel-lite number under each bar. The progress of satellite acquisition is shown in three stages:• No signal strength bars— the receiver is looking for the satellites indicated.• Hollow signal strength bars— the receiver has found the indicated satellite(s) and is collecting data.• Solid signal strength bars— the receiver has collected the necessary data and the satellite(s) areready for use.Once the receiver has collected information from at least three satellites, the top of the screen willdisplay either “Ready (2D or 3D)”, and the GPSMAP 182/182C/232 is ready for use.Point to your approxi-mate location and pressENTER/MARK.A satellite’s strength barswill turn black when it’sready for use.,