35ReferenceProximity Waypoint List2. Use the ARROW KEYPAD to highlight ‘Delete All’ and then press ENTER/MARK.3. Highlight the ‘OK’ prompt and press ENTER/MARK to confi rm.Proximity Waypoint ListThe second waypoint submenu list available from the ‘Points’ tab is the ‘Proximity’ list, which letsyou define an alarm circle around a stored waypoint position, and can be used to help you avoid reefs,rocks or restricted waters. Up to ten waypoints may be listed, with a maximum alarm radius of 99.99nautical or statute miles or kilometers. If a proximity alarm circle overlaps with an existing alarm circle,a ‘Proximity Overlaps Another Proximity Waypoint’ message will appear. Since the unit will only alertfor one of the overlap points, use caution when navigating in these areas. If you enter an alarm circleoverlap, you will only be alerted to the closest proximity waypoint.To add a proximity waypoint:1. Use the ARROW KEYPAD to highlight an empty space on the Proximity list and pressENTER/MARK. The ‘Find’ screen appears. Highlight ‘Waypoints’ and press ENTER/MARK.2. To select a waypoint from the lists, use the ARROW KEYPAD to highlight the desired waypointfrom the ‘User’ or ‘Nearest’ tab lists.To select a waypoint from the map, highlight either the ‘User’ or ‘Nearest’ tab and press MENU.With ‘Select From Map’ highlighted, press ENTER/MARK. Use the zoom IN and OUT buttons andthe ARROW KEYPAD to highlight a waypoint.3. Press ENTER/MARK to confirm. The distance fi eld will now be highlighted.4. Press ENTER/MARK to begin entry of the proximity radius.5. Use the ARROW KEYPAD to enter a distance value (to 99.99 units) and press ENTER/MARK.To turn proximity alarms on or off:1. Use the ARROW KEYPAD to highlight the field below “Proximity Alarm” and pressENTER/MARK.2. Select the desired ‘ON’ or ‘OFF’ setting and press ENTER/MARK.You can also search for a waypoint by name:1. Highlight the name fi eld and press ENTER/MARK.2. Use the ARROW KEYPAD to select the fi rst letter ofthe name.3. Move to the RIGHT and enter the second letter if you donot see it on the list below.4. Repeat this until the name appears. Press ENTER/MARKwhen you see the name.5. Highlight the name on the list and press ENTER/MARKagain to review the waypoint. When done, highlight ‘OK’and press ENTER/MARK.NameFieldWaypointList