Garmin GPSMAP 4010 Owner's Manual

Also see for GPSMAP 4008 - Marine GPS Receiver: Technical reference Important safety information Owner's manual Supplement Owner's manual

Contents

Garmin GPSMAP 4010 Owner's Manual Manual pdf 40 page image

3 GPSMAP ® 4000/5000 Series Owner’s ManualConfiguring the ChartplotterConfiguring theChartplotterSafe Height—set the minimum height (chart height datum) of a bridge that your boat can safelytravel under.Shoreline Distance—set how close you want to travel near the shore: Nearest, Near, Normal,Far, or Farthest. This is used by the automatic guidance calculation to determine how closeto the shoreline you want the automatic-guidance line to be. Changing this while navigating anautomatic-guidance line will recalculate the path.Keel Offset—offset the surface reading for the depth of a keel, making it possible to measure depthfrom the bottom of the keel instead of from the transducer location. Enter a positive number to offsetfor a keel. Enter a negative number to offset for a large vessel that may draw several feet of water.To adjust the Keel Offset:1. From the Home screen, select Configure > My Boat > Keel Offset.2. Use the ROCKER (GPSMAP 4000 series) or the onscreen keyboard (GPSMAP 5000 series) tospecify the offset.3. Select Done to accept the number.NOtE: Select Cancel to cancel your changes and return to the My Boat screen.temp Offset—set the temperature offset for the temperature sensor of your transducer.Calibrate Water Speed—use this menu to calibrate a speed-sensing device. Follow the on-screendirections for calibration. If you do not have a speed-sensing device, this menu does not appear.NOtE: If the boat is not moving fast enough or the speed sensor is not registering a speed, a “SpeedToo Low” message appears. Select OK and safely increase boat speed. If you get the message again,stop the boat and make sure the speed-sensor wheel is not stuck. If the wheel turns freely, check thecable connections. If you continue to get the message, contact Garmin Product Support.Fuel Capacity—enter the total fuel capacity of your boat.Configuring Other VesselsTo configure settings for boats other than your own, from the Home screen, select Configure >Other Vessels.AIS—turn AIS (Automatic Identification System) on or off. AIS alerts you to area traffic byproviding boat IDs, position, course, and speed for boats that are within range and equipped with atransponder.DSC—turn DSC (Digital Selective Calling) on or off.NOtE: To configure AIS or DSC information for other boats, your unit must be connected to anexternal AIS or DSC device.Collision Alarm (AIS and MARPA only)—turn a safe zone around your boat on or off. This is usedfor collision avoidance, and can be customized.To customize safe-zone settings:From the Home screen, select Configure > Other Vessels > Collision Alarm.Range—change the measured radius of the safe-zone ring to a specified distance from 500 ft.to 2.0 nm (or from 150 m to 3.0 km, or from 500 ft. to 2.0 mi).Time to (Safe Zone)—sounds an alarm if AIS or MARPA determines that a target will intersectthe Safe Zone within the defined time interval (ranging from 1 to 24 minutes).••••