4-22 Garmin GTN 725/750 Pilot’s Guide 190-01007-03 Rev. JForewordGettingStartedAudio &Xpdr CtrlCom/NavFPLDirect-ToProcChartsWpt InfoMapTrafficTerrainWeatherNearestServices/MusicUtilitiesSystemMessagesSymbolsAppendixIndex4.2.4.2 Creating a Sector Search PatternThe Sector Search SAR pattern starts at the initial waypoint and follows theinitial track for the desired leg length. A 60° turn in the initial turn direction isfollowed by another leg with the desired leg length, another 60° turn, and thena leg back to the initiating waypoint. The next sector starts with a leg continuingon the same course outbound from the initiating waypoint and is followed bythe same sequence of legs and turns. The third sector follows the same pattern.Selected InitialWaypointSector SearchPattern SelectedTouch To SelectInitial TrackTouch To Select InitialTurn DirectionTouch To Select LegLengthTouch To Load SelectedPattern To Active FPLTouch To Load Selected PatternTo Active FPL & Go Direct-ToInitial WptFigure 4-32 Search and Rescue Sector Search Pattern Page1. Touch the SAR Pattern key and select Sector Search as thepattern type.2. Touch the Initial Track key to open the keypad. Use the keypadand Enter to select the initial course.3. Touch the Initial Turn Direction key to select between Leftor Right as the initial turn direction.4. Touch the Leg Length key to open the keypad. Use the keypadand Enter to select the length of the parallel track legs.5. Touch the Load Pattern key to load selected pattern to theactive flight plan.Or6. Touch the Load Pattern & Activate key to load selectedpattern to the active flight plan and go direct-to the initialwaypoint.190-01007-03-Final.indb 22 7/9/2015 2:07:07 PM
