190-00906-01 GTX 23 Installation ManualRev. C Page B-10B.6 Daisy Chain between Methods A and BIn rare situations where more braids need to be terminated for a connector than three per ring terminal anda mixture of Methods A and B have been used, it is allowable to daisy chain a maximum of two shieldstogether from a Method A termination to a Method B (Figure B-7). All other restrictions and instructionsfor the shield termination technique set forth for Method A and B are still applicable.NOTEThe maximum length of the combined braids should be approximately 4 inches.Figure B-7 Daisy Chain between Methods A and BB.7 Splicing Signal WiresNOTEFigure B-8 illustrates that a splice must be made within a 3 inch window from outside theedge of clamp to the end of the 3 inch max mark.WARNINGKeep the splice out of the backshell for pin extraction, and outside of the strain relief toavoid preloading.Figure B-8 shows a two wire splice, but a maximum of three wires can be spliced. If a third wire is spliced,it is located out front of splice along with signal wire going to pin.Splice part numbers:• Raychem D-436-36/37/38• MIL Spec MIL-S-81824/1This technique may be used with shield termination methods: A.1, A.2, B.1, and B.2.
