190-00906-01 GTX 23 Installation ManualRev. C Page C-3APPENDIX C Interconnect Drawings (Example Only)Figure C-3 TIS Display Options ExampleGTX 23P2301ARINC 429 OUT 2 AARINC 429 OUT 2 B3028P4001/5001GNS 4XX/5XX50 ARINC IN 2A46TIS CONNECT SELECT5111ARINC IN 2BANNUNCIATE ETIS SetupThe GDU 37X will display TIS traffic data from the GTX 23, but one also has the opon of displaying TIStraffic data on a GNS 4XXW/5XXW-series unit.Direcons for setng up a GNS 4XXW/5XXW-series unit to display TIS data:- Following direcons in the GNS installaon manual, go to the ARINC 429 configuraon page.Configure the ARINC input connected to the GTX to:o Speed=Higho Format=Garmin GTX 330NOTES:1. THE CONNECTIONS ON THIS PAGE ARE OPTIONAL. THE GDU 37X WILL DISPLAY TIS DATA. THESECONNECTIONS ENABLE TIS TO BE DISPLAYED ON A GNS 4XXW/5XXW-SERIES UNIT.2. IF TIS WILL BE DISPLAYED ON A GNS, THE GNS MUST BE CONFIGURED FOR THIS SETUP. PLEASESEE THE FOLLOWING CONFIGURATION GUIDANCE.3. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE NOTED.4. THE GTX 23 REQUIRES THAT ARINC 429 OUTPUT #2 BE USED FOR TIS, BUT ANY UNUSED ARINC429 INPUT ON THE GNS MAY BE USED.5. WHEN TIS IS USED ON A GNS, DO NOT CONNECT ANOTHER TRAFFIC SYSTEM TO THE SAME GNSSERIES UNIT.6. THE SINGLE WIRE CONNECTED TO THE TIS CONNECT SELECT INPUT OF THE GTX 23 IS OPTIONAL.THE GNS CAN COMMAND THE GTX TO PUT TIS IN STANDBY MODE. THIS WIRE IS NECESSARY TOPUT TIS INTO AND BRING IT OUT OF STANDBY MODE.
