Installation Procedure190-01499-02 GTX 3X5 Transponder TSO Installation ManualRev. 9 Page 4-3[3] Supplied as part of GTX connector kit P/N 011-02977-00 (GTX 335), andP/N 011-02977-01 (GTX 345).[4] Not supplied – must be purchased separately.[5] Solder sleeve with pre-installed shield drain wire may be used instead of items 12 and 13.[6] Not a Garmin part number.4.3 Shielded Cable PreparationNOTESolder sleeves with pre-installed shield drains can be used instead of separate shield terminators (12)and individual wires (13). A preferred solder sleeve is M83519/2-X series with a pre-installed shielddrain.Prepare all of the shielded cables using one of the methods shown in figure 4-1. For details of the shield termination tothe connector backshell refer to figure 4-2.1. At the end of the shielded cable (11), strip back a 2.5" maximum length of the jacket to expose the braid.2. Remove the exposed braid.3. Carefully score the jacket 1/4" to 5/16" from the end and remove the jacket to leave the braid exposed.4. Connect a 20 or 22 AWG wire (13) to the exposed shield of the prepared cable assembly. Refer to figure 4-1. Fortermination techniques refer to AC 43.13-1B.5. Slide a shield terminator (12) onto the prepared cable assembly (11).6. Connect the shield wire (13) to the shield using a heat gun approved for use with solder sleeves.7. Crimp contacts (14) onto the cable wires. Refer to section 4.1.8. For the remaining shielded cables, repeat steps 1 through 7 as necessary.9. Install a ring terminal (15) onto the cable shield termination wires (13).10. Group wires as applicable for the connector. Refer to section 4.4.
