Installation Procedure190-01499-02 GTX 3X5 Transponder TSO Installation ManualRev. 9 Page 4-84.5 Configuration Module InstallationNOTEInstallations with an optional GAE module do not require a configuration module.NOTEThe configuration module stores unit configuration data. This lets the installer remove and replace theGTX without loss of configuration data. Installation of the module is part of the aircraft harness.GTX 335 and GTX 345 standard kits include a configuration module. Garmin recommends to use the configurationmodule with these models, but it is not required.Do not install the configuration module in the connector backshell when the GAE is installed on the connectorbackplate. The GAE module has a built-in configuration data storage device and interfaces to the GTX 3X5 through thesame pins as the configuration module.The GAE wire harness is routed out the back of the backshell and plugged into the GAE when the backplate isassembled. Refer to section 5.12 and figure B-11.For this procedure refer to figure 4-4 and figure D-1.1. Remove 0.17 inches of insulation from the end of each wire (2).2. Crimp socket contacts (3) onto each wire of the four-conductor wire harness (2).3. Insert crimped socket contacts (3) and wires (2) into the applicable connector housing location.Refer to figure D-1.4. Plug the four-conductor wire harness (2) into the connector on the configuration module (1).5. Insert configuration module (1) into the backshell recess.6. Point the connector housing so the inserted four conductor wire harness (2) is on the same side of the backshellas the configuration module (1).
