Garmin NVI 760 Owner's Manual

Also see for nuvi 760: Product information Quick start manual Safety and product information Owner's manual Owner's manual

Contents

nüvi 760 for Volvo cars Owner’s ManualaPPendixTroubleshootingProblem/Question Solution/AnswerMy nüvi never gets satellitesignals.Take your nüvi out of parking garages and away from tall buildings andtrees. Remain stationary for several minutes.How do I clear all my userdata?Hold your finger on the lower-right corner of the nüvi’s screen while it isturning on. Keep your finger pressed until the message appears. TouchYes to clear all user data.The nüvi is locked up/frozen.If the nüvi screen stops functioning, turn the nüvi off and on again. If thisdoes not help, slide the Power key to the left and hold for 8 seconds.Turn the nüvi back on. The nüvi should operate normally.The touch screen is notresponding to my tapsproperly.Turn the nüvi off and then back on. Slide Power key to the right (lock).Hold your finger on the screen for about 30 seconds until the calibrationscreen appears. Follow the on-screen instructions.My battery gauge does notseem accurate.Allow the unit to fully discharge, and then fully charge it (withoutinterrupting the charge cycle).My phone will not connect tothe nüvi.Touch Tools > Settings > Bluetooth. Verify that the Bluetooth field is setto Enabled.Make sure your phone is turned on and is less than 10 meters (about 33feet) away from your nüvi.See www.garmin.com/bluetooth for more help.How do I know my nüvi is inUSB mass storage mode?When your nüvi is in USB mass storage mode, a picture of a nüviconnected to a computer is shown. Also, you should see two newremovable disk drives listed in My Computer.My computer never sensesthat the nüvi is connected.1. Unplug the USB cable from your computer.2. Turn the nüvi off.3. Plug the USB cable into your computer and your nüvi. The nüviautomatically turns on and goes into USB mass storage mode.