Gas & Wood 2200 Owner's Manual
                           | |
Contents
| 
/1410. Never operate the insert with the door open, or cracked slightly open, except briefly during thelighting operation, and during refuelling. Leaving the door open continuously could seriouslyoverheat the chimney and adjacent combustibles. Do not operate the insert if there is an abnormalair leakage into the unit, such as through deteriorated gaskets or cracked or broken glass. Do notoperate the insert without a door gasket. Leakage can result in overheating, or in very airtighthomes, could possibly cause smoke spillage into the room. Smoke may contain carbon monoxide,which is poisonous, and in sufficient quantities is a health hazard.11. We recommend that you have a fresh air or make up air supply for the insert. In Canada this is abuilding code requirement. If this is not done, it could cause poor air quality in the home, poorand incomplete combustion, and poor efficiency in the insert.3.2 Fuel1. Fuel for the insert must not be stored closer than the required clearances to combustibles and not inthe space required for ash removal.2. Your Osburn insert is designed to burn CORDWOOD FUEL ONLY. Do not burn coal, charcoal, ortrash in the unit. Highly flammable items such as trash may ignite creosote in the chimney,resulting in a chimney fire. Never burn salt wood, beachwood, chemically treated wood, or woodremoved from salt water, since the deposits left will deteriorate the firebox. Damage caused bychemicals or salt is not covered under warranty.3. Seasoned dense wood is recommended. Wood should be air dried in a covered ventilated area forsix months to a year or more. This reduces the moisture content of the wood, resulting in betterinsert performance. Wood species with a moisture content of 20% or less are ideal. Dry seasonedwood can be distinguished from green wood by the checks or cracks in the ends.4. Wet or green wood will tend to cause the fire to smoulder, producing large amounts of creosote.Creosote build-up could result in a chimney fire. This wood will also prove difficult to keepburning properly, and fires will tend to go out. Green wood produces very little heat, andsometimes causes customers to think that the insert does not work. If you must burn wet wood,use only small amounts mixed with dry wood.5. Decayed wood or low density wood has very little energy content or heating value, and will notburn satisfactorily for long periods of time.An example of the energy values of some common wood fuels is given in Table 3.1For recommended wood sizes, refer to the specifications. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine