Gastroback Latte Magic 42325 Operating Instructions Manual

Contents

33Do not operate the appliance with the filling level below the MIN filling mark or exceedingthe MAX filling mark. Ensure not to spill any liquids on the power base. The jug must alwaysbe clean and dry, when placed on the power base to avoid risk of electric shock or damage.1. Place the power base on a flat, stable, moisture-resistant and heat-resistant surface near asuitable wall power outlet (see: ›Important Safeguards‹) with the START/STOP button facing toyou. Leave at least 10 cm of free space to walls, curtains, boards and other objects on eachside of the appliance. Leave at least 50 cm of free space above the appliance to get unhinde-red access. Ensure that the appliance is unplugged.note: Clean the jug with cold water before frothing milk.2. Take the milk frothing disc and place it with the bulge pointing up-wards between the three pins on the frothig disc mount - the spiral isbrought by a magnet to the correct position. (pic. A and B).3. Grab the dic mount with the inserted frothing disc and place it up-right, the long pin facing up (see pic C) at the bottom of the foam jug.4. Pour the desired amount of chilled milk into the jug. You can useskim milk or whole milk. Pay attention to the MAX mark the inside ofthe jug when pouring the milk. The MAX mark for heating milk is 250ml and the MAX mark for frothing milk in 150 ml. The MIN mark is100 ml. For frothing milk you need less milk because the finished foamhas a larger volume than heated milk and would otherwise overflow.Keep the container it as upright as possible. (see pic D).note: Take the jug of the power base before filling.IMpOrtant: There are two max level indicators inside the jug. Thelower level max level indicator is for frothing milk and the upper maxlevel indicator for heating milk (picture C). You need less milk forfrothing because the volume of milk froth is bigger then the volumeof heated milk. Using too much milk when frothing would cause over-running.IMpOrtant: Never overfill the jug. Spilling liquids can cause da-mage to the electronic components.nOte: The volume, texture, and taste of froth vary depending on thefat content and amount of milk and flavouring used. The milk frotherproduces the greatest volume of rich, thick, froth using cold, fat freemilk. 0,3%,1,5%, 3,5% and whole milk froth well, but due to a higherfat content they produce a froth with a slightly different texture and lessvolume but sweeter. To prepare toppings for coffee or dessert, using the maximum amountof milk will produce approximately 3-4 servings generous servings.nOte: To make flavoured froth, frothy drinks, dessert toppings or desserts, you may addsyrups, powders, sugar, sugar substitutes or liqueurs to the milk. See milk froth recipes in theback of the manual instructions.5. Place the lid on the jug and ensure the it is closed properly.6. Place the jug onto the power base. The electric contacts of the multi-directional power base will slide into a corresponding opening in thebottom of the jug. The power base will work out in any orientation. Thestart button is on the jug (picture E).7. Place the plug into the power outletBCAD100 ml150 ml250 mlE