Gastroback Latte Magic 42325 Operating Instructions Manual

Contents

30Moving partsThe milk frothing disc of the appliance is driven electrically via a magnet. Thus, you shouldalways avoid inserting your hands, or any delicate objects in the jug, when the jug is placedon the power base and the appliance is connected to the power supply.tecHnIcaL specIfIcatIOnsModel: Art.-Nr. 42325 Latte Magic / 42326 Latte MagicPower supply: 220 – 240 V AC, 50 – 60 HzPower consumption: 420 – 500 WRevolutions: 2,500 – 3,000 per minuteLength of power cord: ca. 75 cmWeight (with lid): ca. 0.88 kgDimensions: ca. 15.5 cm x 12.0 cm x 20.0 cm (width x depth x height)Capacity: 0.5 LitreCompliance:prOpertIes Of yOur new MILk frOtHerYour new Milk Frother has been designed specifically for the purpose of foaming milk andmilk alternatives.IMpOrtant: The appliance is not intended to thicken or heat other food substances (e.g.custards, soups, gravies), or to whip cream or egg white. Additionally, the appliance is not in-tended to mix a large quantity of dry and/or solid ingredients (e.g. ground nuts, spices, flour,cacao powder, herbs) or melt large pieces of food (e.g. chocolate or butter).The frothing disc is driven contact-less via magnets. No opening for a drive shaft is necessaryin the jug, thus avoiding weak points and leaks. As a result, cleaning is made much easier,too. Due to the seal at the brim of the lid, the contents will not drip or splash out of the jug,when operated correctly.safety conceptFor your protection and convenience, your new milk frother offers an innovative design.• After being used the milk fFrother will switch off automatically and the illuminated buttonturns off.• Overheat protection: The Milk Frother will automatically cease to operate, if the jugoverheats. Wait 30 seconds before turning the appliance back on.• The appliance operates via an magnetic drive system. Thus, injuries are avoided as far aspossible, because you cannot unintentionally touch any heated or moving parts in the powerbase. Just keep in mind that the jug is heated and thus, everything touched by the hot jug willget hot, too. Therefore, after operation and removing the jug, let the power base cool downfor some minutes, before moving or cleaning.