Gastroback Latte Magic 42325 Operating Instructions Manual

Contents

36• Never immerse power base or cord in water. Clean the power base with a warm dampcloth or sponge and dry with a soft towel. Do not let any liquid run into the power base.cleaning of the frothing DiscTake the frothing disc off the shaft and carefully wash with warm soapy water using a spon-ge or scrubber pad. Rinse with water and dry with a soft towel.note: In case of grease residues on the frothing disc, the frothing process will be disturbed,because the grease of the fresh milk can not get filtered out. The result will be less or no froth.cleaning of the Jug• Never immerse the jug in water.• The jug should never be placed in an automatic dishwasher! This would cause damage tothe electronic components in the bottom of the jug.• Immediately after each use place a small amount of warm water in the jug to soak. Thewater helps prevent the build up of ingredients on the non-stick coated surface and makescleaning easier.• Carefully wash the jug and lid with warm soapy water using a sponge or cloth that issuitable for cleaning non-stick coating. Rinse with cold water and dry with a soft towel.• Be careful not to damage the non-stick coating of the jug.• attentIOn: Never use abrasive cleaners, any chemicals, disinfectants, cleaning padsor any sharp utensils (i.e. metal scouring pads) for cleaning.• Clean the outer housing of the jug with a warm damp cloth or sponge and dry with a softtowel. Do not let any liquid run into the housing of the jug.• IMpOrtant: Ensure to clean all residues from the bottom of the jug to avoid scorch ofingredients.• Always rinse the jug with clear cold water before frothing.• To clean stubborn residues fill some dishwasher detergent into the jug and add a littlebit of hot water. Soak the residues for approximately 15 minutes before emptying the jug.Thoroughly rinse the jug with cold clear water afterwards.• To clean all residues of the detergent assemble the appliance, fill the jug to the max levelindicator for frothing milk (120 ml) with clear cold water and turn the appliance on. Pour outthe water. The appliance is ready for use.• Occasionally, it is recommended to operate the appliance with a small amount of nonsud-sing detergent. Fill jug to the max level indicator for milk froth with warm soapy water andturn the appliance on. Rinse thoroughly with cold clear water afterwards.• Care should be taken when cleaning smaller parts, such as the attachments, to avoidaccidentally dropping in the garbage disposal or discarding in the trash.• Prior to use and between consecutive cycles, the appliance should be rinsed with coldwater to insure proper operation.warnIng : To reduce the risk of fire or electrical shock, do not remove the bottom coverfrom the power base or disassemble the containers heating unit. Repair should be done byauthorised service personnel only.