Gecko Y Series Tech Book
Also see for in.yt-7-CE: Quick start card
                              | |
Contents
| 
22Electrical wiring: European model in.ytPJ2PJ1NL1GN PJ2PJ1L1L2GL3 PJ2PJ1L1L2GN PJ2PJ1L1L2L3GRefer to wiring diagram in the enclosure box lid for more information�Warningin�yt�ce models must always be connected to a circuit protected by a Residual-Current Device (RCD) havinga rated operating residual-current not exceeding 30 mA� Correct wiring of the electrical service box, RCD, andpack terminal block is essential! Check your electrical code for local regulations� Only copper wire should beused, never aluminum�Connect PJ1 betweenP7 and P13�Connect PJ2 betweenP10 and P74�Connect PJ1 betweenP7 and P10�Connect PJ2 betweenP13 and P74�Connect PJ1 betweenP7 and P10�Connect PJ2 betweenP13 and P74�Connect PJ1 betweenP7 and P10�Connect PJ2 betweenP11 and P13�1-phase 2-phase 3-phase Delta (no neutral) 3-phase with single neutralInsert each wire into the appropriate socket of the main entry terminal block according to the color code indicated on thesticker� Use a flat-head screwdriver to tighten the screws on the terminal�After making sure wires are securley connected, push them back into the box and replace the cover� Do not over tightencover screws (torque to 8 in� lb max {0�9 N�m})�Connect the bonding conductor to the bonding lug on the front of the spa pack (a grounded electrode conductor shouldbe used to connect the equipment grounding conductors)�Electrical wiring |
Related manuals for Gecko in.yt-7-CE
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine