PAG.10 PAG.11WARNING!USE AND MAINTENANCEPlease note that the alarm system is still an electronic device, so must behandled carefully.The following are simple hints which are useful if you want to prevent devicedamage because of an improper use.Do not clean the alarm with water.Do not expose the alarm to heat sources.Do not use power supply voltages which are different than those specifiedby the factory label.If the motorbike is cleaned with a washing machine, be careful not todirectly expose the alarm to the water jets.Use a damp cloth to clean the alarm.GEMINI TECHNOLOGIES S.p.A. IS NOT RESPONSIBLE FOR DAMAGESTO THE ALARM IN CASE OF AN IMPROPER USE OF IT.!!!!!WARRANTY CONDITIONSThis apparatus is guaranteed against all defects of fabrication for a period of 24months from the installation date shown on the warranty coupon below, takinginto consideration the 1999/44/CE.Please fill in the warranty certificate contained in this instruction booklet in all itsparts and DO NOT REMOVE the warranty label on the apparatus.If the warranty label is lost or damaged or if the data on the warranty certificateis not complete or if the attached sale document is missing, the will notrecognize this warranty.The warranty is valid exclusively at centers authorized by GeminiThe manufacturer declines all responsibility for any defects or malfunctions ofthe alarm and of the vehicle electric system if the apparatus is installedincorrectly, mishandled or improperly used.The alarm has only a dissuasive function against thefts.NOTE: Any type of modification or addition not expressly indicated onthe installator manual or authorized by Gemini Technologies S.p.A., willinvalidate automatically the installation certificate and product warranty.TechnologiesS.p.A.WARNING:Use only type CR1616 batteries.Using batteries different from those advised can seriously damage the remotecontrol unit.Do not discard used batteries in the environment; they should be disposed of inappropriate containers.REPLACING REMOTE CONTROL BATTERIESThe remote control operates using alkaline batteries.Under normal use conditions of the remote control these will gradually losetheir charge.The more you use the remote control, the sooner the batteries will becomedischarged.To prevent problems with the remote control, it has been provided with a devicethat will signal the charge condition of the batteries inside.During normal use of the remote control, when you press a command buttonthe green transmission LED will light up with a steady light.If the battery charge drops below the level needed to assure correct operationof the remote control, when you press a command button the greentransmission LED will blink, advising you that it is time to replace the batteries.For battery replacement follow the indications reported below.Separate the plastic shells of the remote control paying attention to notdamage the internal circuit.Remove the discharged batteries.Insert the new batteries in their housing, being careful to not invert thepolarity.Close the plastic shells of the remote.Verify the efficiency of the remote control.!!!!BATTERIES