GEM-P816 Installation InstructionsPage 57NAPCO Security SystemsRFCC STATEMENTThis equipment generates and uses radio-frequency energy and, if not installed and used properly, that is, in strictaccordance with the manufacturer's instructions, may cause interference to radio and television reception. It has beentype tested and found to comply with the limits for a Class-B computing device in accordance with the specifications inSubpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in aresidential installation.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does causeinterference to radio or television reception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the following measures: reorient the receiving antenna;relocate the computer with respect to the receiver; move the computer away from the receiver; plug the computer into adifferent outlet so that computer and receiver are on different branch circuits.If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.The user may find the following booklet prepared by the Federal Communications Commission helpful: "How to Identifyand Resolve Radio-TV Interference Problems". This booklet is available from the U.S. Government Printing Office,Washington, DC 20402; Stock No. 004-000-00345-4.CAUTION: This equipment generates and uses radio-frequency energy. If not installed using conventional installationpractices for RF devices, it may cause interference to radio and television reception. It has been tested and found tocomply with the limits for a Class A computing device pursuant to Subpart B of Part 15 of FCC Rules, which aredesigned to provide reasonable protection against such interference. However, there is no guarantee that interferencewill not occur in a particular installation. If it has been found to cause interference to radio or television reception, whichcan be determined by removing and reapplying AC and battery power to the equipment, the installer should try tocorrect the interference by one or more of the following measures: reorient the receiving antenna; connect the powertransformer to a different outlet so that the control panel and receiver are on different branch circuits; relocate thecontrol panel with respect to the receiver.