Gemini KIT Parking Sensor 818W Installation And Use Manual

Contents

Gemini KIT Parking Sensor 818W Installation And Use Manual Manual pdf 4 page image

PAGE 02 USER MANUAL - PAGE 03UK TABLE OF CONTENTSFor the overall functionality of the system, check the programming of all the sensors,front and rear.Detection zones are indicated as “F” (front) and “R” (rear).Detection zones closest to the obstacle are indicated as “FC” (front) and “RC” (rear)and displayed as “STOP”.The STOP zone is the minimum distance detected between an obstacle and the sensorand in this case the warning tone is solid.The detection range and the volume of the buzzer can be adjusted (see “setting ofparameters”) according to the needs of the user and the vehicle on which the system isinstalled. The sound alert will vary according to the distance and thedetection zone (front or rear).stage-by-stage2.1 - DETECTION ZONESZONE ZONERCR1R2R3R4R5FCF1F2F3DISTANCE DISTANCE35 cm60 cm85 cm110 cm135 cm160 cm35 cm50 cm65 cm80 cmThe rear sensors deactivated with the push-button on the display will stay deactivatedeven when system is reactivated (reverse gear is engaged).To reactivate them press the push-button.The front sensors operate according to connections and settings.CENTRAL SENSORS: black zones.LATERAL SENSORS: black contoured zones.CLOSEST DETECTION ZONE: the STOP sign and the two symbols next tothe vehicle diagram turn on. The distance indication turns off.1.02.05.07.08.09.010.011.012.014.0- PRELIMINARY ADVICE............................................................................................- SYSTEM OPERATION..............................................................................................2.1 - Detection Zones......................................................................................................2.2 - Rear sensors...........................................................................................................2.3 - Automatic activation of front sensors (odometer signal)..........................................2.4 - Timer-activated front sensors (odometer not connected).............................................................................................................................................................3.2 -......................................................................3.4 - Others................................................................................................................................................................................-WARRANTY CONDITIONS.......................................................................................- WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE) DIRECTIVE......- INSTALLATION OF SENSORS.................................................................................- CONNECTIONS........................................................................................................- ..................................................- ...............- TESTING.............................. ....................................P ...............................................................................................- ..................................USER MANUALINSTALLER MANUAL.3.04.06.013.0- TROUBLESHOOTING GUIDE.....................................3.1 - Low power supply signal.................Front sensors anomaly indication............................................................................3.3 - Rear sensors anomaly indication......- SETTING OF OVERSPEED AUDIBLE ALERTDISPLAY....................................................................................................................-PAIRING OF CONTROL UNITS WITH DISPLAY..LEARNING OF ODOMETER PULSES (optional, only with display wire)................................................- ROGRAMMING......SETTING OF PARAMETERS................................................PAGE 02PAGE 03PAGE 03PAGE 04PAGE 05PAGE 05PAGE 05PAGE 05PAGE 06PAGE 11PAGE 04PAGE 04PAGE 06PAGE 07PAGE 07PAGE 07PAGE 08PAGE 12PAGE 12PAGE 13PAGE 14PAGE 151.0 - PRELIMINARY ADVICEDear customer,Before installing, identify your kit and refer to it for the correct instructions.The Caution and Warning signs in this manual provide important notices for installing and using thisproduct.Be sure to follow them in order to ensure a safe and reliable use:For the user.This sign highlights useful information or indications regarding the use of the parkingsystem.For the installer.This arious operating modes.sign indicates v according to connections andprogramming of the system or it simply provides useful indications for the installation!2.0 - SYSTEM OPERATIONUSER MANUALThe parking system is designed only as a parking aid, it should not be considered toreplace care and attentiveness while manoeuvring.Remember to always look around the vehicle while parking.Small obstacles or objects with low reflectance might not be detected.80135160356560508511035