Genie CHAINMAX 1200 4022 Operation And Maintenance Manual

Contents

Genie CHAINMAX 1200 4022 Operation And Maintenance Manual Manual pdf 14 page image

14SETPROGRAMOpenTravelButtonROUNDLED Indicator(Light)FacingGarage DoorLONGLED Indicator(Light)CloseTravelButtonOVERVIEW OF POWERHEAD CONTROLSThis section describes the simple programmingfunctions. Use this page to familiarize yourself with thebuttons and LED indicators used to program the opener.NOTE: These and buttons are for programming useonly. Do NOT use these buttons to operate the opener.PROGRAMSET—+To garage doorFIG. 4-1 Locate programming buttonsFIG. 4-2 Programming buttonsThere are three programming buttons and two lights(LEDs) on the powerhead.Each of the buttons are used to enter and completethe setup programming. The LEDs indicate status or afunction change by illuminating ON, OFF, or ON flashingin one of three different colors: BLUE, RED, or PURPLE.Throughout the instructions in this manual the buttonsand LEDs are also displayed as icons.ButtonsName Shape UseProgram buttonPROGRAMSETEnters into and selectsprogramming menusClose Travel button multi-function;moves door, advancesthrough menusOpen Travel button multi-function;moves door, advancesthrough menusLED ColorsRound Red and Long RedRound Purple and Long PurpleRound Blue and Long BlueProgramming OverviewThere are four Powerhead program menus:Remote Program (Default menu)Limits ProgramSpeed Program*Force Program*Programming steps for Limits and remotes are found onpages 6 through 10.*Force and Speed settings are set at the factory and donot normally require adjustment programming. Customprogramming instructions for Speed and Force arelocated in the Troubleshooting Section of this manual.These are the basic steps to enter into the fourprogramming menus:1. Press PROGRAMSETand hold until both BLUE lights come ONthen release.2. Both LEDs go out and Round BLUE light comesON. You are in the Program Menus at the RemoteProgramming.By using the or the button you can navigate tothe Limits, Speed, or Force program menus and theLED display will change accordingly.Each program menu has a specific LED display.Press Program LED DisplayDefault Remote Round BlueLimits Long BlueX2 Speed Round Blue & Long BlueX3 Force Round Red3. Press PROGRAMSETbutton to enter into the program menufunctions.If you have entered into an unwanted program menuand are not sure where you are - do not press anybuttons for 30 seconds. The programming functionwill time out after 30 seconds if there is no key strokeactivity.4Programmingbuttons locationon powerhead.©2011 The Genie Company 3/2011