Genie CHAINMAX 1200 4022 Operation And Maintenance Manual

Contents

Genie CHAINMAX 1200 4022 Operation And Maintenance Manual Manual pdf 5 page image

Begin here after the opener's physical assemblyand installation has been completed.There are no assembly or installation steps included in this manual. Contactyour Genie® Professional Dealer for an installation poster, if required, or visitwww.geniecompany.com to download a PDF file.The following mechanical assembly tasks must be completed before continuing. Powerhead and rail are bolted to each other (An illustration is shown on page 11)Example illustrations of the following items are shown on pages 12 and 13 Rail end is attached to a header bracket which is attached to the garage door header Powerhead is attached to a support frame suspended from the ceiling or ceiling joists Both pieces of door arms are assembled and are attached to the garage door Safe-T-Beam® sensors installed and wired Wall console installed and wired (Shown on page 20) Carriage is engaged to the chain drive (An illustration is shown on page 11) Powerhead is plugged into an approved power outletBegin programming by setting Limits (see next page.)©2011 The Genie Company 3/2011 5IMPORTANT INSTALLATION INSTRUCTIONSWARNING:Toreducetheriskofsevereinjuryordeath:1. READ AND FOLLOW ALL SAFETY, INSTALLATIONAND OPERATION INSTRUCTIONS. (If you havequestions or do not understand an instruction, callThe Genie Company.)2. Install only on a properly balanced sectional orone piece garage door. An improperly balanceddoor could cause severe injury. Have a trained doorsystem technician make repairs or adjustments tocables, spring assemblies, and other hardware beforeinstalling the opener.3. Remove all ropes and remove or make inoperative alllocks connected to the garage door before installingopener.4. Where possible, install the door opener 7 feet ormore above the floor. For products having anemergency release, mount the emergency releasewithin reach but, at least 6 feet above the floor to avoidcontact with vehicles to prevent accidental release.5. Do NOT connect the opener to source of power untilinstructed to do so.6. Locate the wall console:s Within sight of the garage door,s At minimum height of 5 feet so small childrenare not able to reach it, ands Away from all moving parts of the door.7. Install the Entrapment WARNING Label next to thewall console in a prominent location.8. After installing the opener, the door must reversewithin 2 seconds when it contacts a 1-1/2 inch highobject (or a 2 x 4 board laid flat) on the floor.INFRARED PROTECTION FUNCTION1. When garage door is opening, its movement will not be influenced if the Safe-T-Beam® isobstructed.2. If the Safe-T-Beam® is obstructed before the garage door fully closes, the door will not close.3. When the garage door is closing, if Safe-T-Beam® is interrupted by person or obstacle, the garagedoor will stop its downward travel and reverse automatically to its fully opened position.4. Remove Safe-T-Beam® obstruction.5. If the Safe-T-Beam® System fails, loses power, or is installed improperly, press and hold the wallconsole "open/close" button until the door reaches its fully closed position. If you release the"open/close" button on the wall console during the closing movement the door will reverseautomatically to its fully opened position.A PDF VERSION INSTALLATION POSTER IS AVAILABLE AT WWW.GENIECOMPANY.COMOR CALL 1-800-35-GENIE TO OBTAIN AN EMAIL PDF FILE