Genie Excelerator 3531835447 User Manual

Also see for Excelerator 3531835447: Manual

Contents

Genie Excelerator 3531835447 User Manual Manual pdf 22 page image

_ _OY _ COH]'ROLA To program one Button of a Remote Control (Figure 37):• Locate Learn Button and Learn Indicator Light nearTerminal Block on Power Head (Figure 38).• Press and release Learn Button. Red Learn Indicator Lightwill blink 2 times per second.• Press Remote Control Button once within 30 seconds.Red Learn Indicator Light will stay lit.• Press Remote Control Button again. Red Learn IndicatorLight will go out, indicating that memory is stored.B Program each additional Remote using step A above.7b E_'ase Ail .......... _,,_essetes frown Re e_" Mea_t BJ]e_'_'_eryA Press and hold Learn Button on Power Head for 10 seconds oruntil Learn Indicator Light goes out. Memory is erased:. Program Remotes again as needed.NOTEe Each Remote Control must be programmedseparately.• The Remote Controls will not cause the doorOpener to close the garage door if the Safe-T-Beam® System is malfunctioning.• When programming the Remote Controls, theymust be at least 24" from the Antenna Wire.• Ifthe red Learn Indicator Light blinksapproximately 4 times per second,programming has stopped. If programminghas stopped, repeat the above steps.Each Button on a 2 or 3 Button Remote Controlis for a different Opener. You cannot use morethan one Button per Remote, per Opener.• A maximum of seven Remote Controls orWireless Keypads can be stored into theReceiver at one time. If a Remote Controlbecomes lost, or if you want to delete a RemoteControl or Wireless Keypad, see "To EraseAllReceiver Memory."A Push in on Battery Cover Latch at base of Remote Control(Figure 39):Use coin, pen, screwdriver or any similar device.- Cover snaps open.Replace old Battery with new _EI/_'RE/ID_, A23,12 Volt Battery.B Snap Battery Cover closed.WARNINGA moving garage door may cause serious injury or death.• Keep people clear of opening while door is moving.• Do not allow children to play with the Remote Controls.If the Safety Reverse does not work properly:• Close the door and disconnect the Opener using theEmergency Release Cord.• Do not use the door Opener, Remote Controls, orWireless Keypad.• Refer to the door and door Opener Owner's Manualsbefore attempting any repairs.A Press Button on Remote Control. Garage door will move.B Press Button again. Garage door will stop:• The door automatically stops at the end of the open orclose cycle.C Press Button again. Garage door will reverse.@@@1 Button 2 Button 3 ButtonRemote Remote Remote® ® ®Figure 37 Genie Remote ControlsJLearn Code ButtonLEARN INDICATOR LIGHTFigure 38 Learn Code Button and Indicator LightVisor ClipModelNumber\\Push to openBattery CoverFigure 39 Remote Control Battery Replacement