Genie Excelerator 3531835447 User Manual

Also see for Excelerator 3531835447: Manual

Contents

Genie Excelerator 3531835447 User Manual Manual pdf 26 page image

TO.41LWARNINGREDUCE THE RiSK OF SEVERE iNJURY OR DEATH1 READ AND FOLLOW ALL INSTRUCTIONS.2 Never let children operate or play with the Door Controls. Keep the Remote Control away from children.3 Always keep the moving door in sight and away from people and objects until the door is completely closed.NO ONE SHOULD CROSSTHE PATH OF THE MOVING DOOR.4 NEVERGO UNDER A STOPPED,PARTIALLYOPEN DOOR.5 Test Opener monthly'. The door MUST reverse on contact with a 1-1/2" high object (or a 2" x 4" board laid flat)at the center of the doorway on the floor. After adjusting either the Force or the Limit of travel, retest the DoorOpener. Failure to adjust the Opener properly may cause severe injury or death.6 When possible use the Emergency Release only when the door is closed. Use caution when using this Releasewith the door open. Weak or broken springs are capable of increasing the rate of door closure and increasingthe risk of severe injury or death.7 KEEPGARAGE DOORS PROPERLYBALANCED. See Owner's Manual. An improperly balanced door increases therisk of severe injury or death. Have a Genie Factory Authorized Dealer make repairs to cables, springassemblies, and other hardware.8 SAVETHESEINSTRUCTIONS.. WARNINGUse the Wall Console included with Opener. Any other wall console can cause the Opener to operate unexpectedly andthe light to stop working.TI!;,IOUBLESHOOTI ' ....Source (Red LED) Sensor (Green LED) Possible Problem SolutionON ON Normal operation None required- Power Head not powered - Check breakers, fuses, plugsOFF OFF • Wiring from Power Head bad • Check wiring for obvious shortsOFF ON2 BLINKS, Pause(Repeat)2 BLINKS, Pause(Repeat)3 BLINKS, Pause(Repeat)4 BLINKS, Pause(Repeat)ONOFFON- Wiring to Source missing or bad• Power has been interrupted- Beam not aligned• Beam obstructed• Sensor defective- Wire to Sensor missing or bad• Sensor defective- Check wiring• Remove power and reapply- Check Source, Sensor alignment- Check for obstruction• Contact Customer Service- Check wiring• Contact Customer Service• Sensor receiving interference - Determine source of interference• Contact Customer Service- Source not sending pulses - Contact Customer ServiceON • Source defective • Contact Customer Service