Genie Excelerator 3531835447 User Manual

Also see for Excelerator 3531835447: Manual

Contents

Genie Excelerator 3531835447 User Manual Manual pdf 23 page image

WARNINGA Moving door can cause serious injury or death.1 Keep people clear of opening while door is moving.2 Do Not allow children to play with Wireless Keypad.3 During programming, the door opener could beginto run, so stay away from the moving door and itsparts.To keep the door from moving, dose the doorand disconnect it from the Openerby pulling theEmergency Release.If Safety Reverse does not work properly1 Close door and disconnect the Opener usingEmergency Release Cord.2 Do not use door Opener, Remote Controls, orWireless Keypad.3 Refer to Door and Door Opener Owner's Manualsbefore attempting any repairs.NOTEFOR CONVENIENCE-- Program Keypad BEFOREmounting.A Set Wireless Keypad PIN (Personal ID Number):• Activate programming mode.Coo- Press (in order)- Red LEDblinks - once per second.Enter your PIN(3 to 8 characters).PressProgramming One Door Operator:• Find the Learn Code Button and Learn CodeIndicator LEDon your door opener.- Ifyour door opener has a black antennawire,the Learn Code Button and IndicatorLEDare located near the antenna.(The light lens may need to be opened)- Ifyour door opener doesnot have anantenna, you have an external receiver.The external receiver cover must beremoved to accessthe Learn CodeButton and Indicator LED.• Pressthe Learn Code Button.- LearnCode Indicator LED(on Opener)will blink.Enteryour PINand press _.- Learn Code Indicator LEDstays on.• Press_ again.- Learn Code Indicator LEDturns off.RedLEDblinks-twice persecondand turnsoff.Figure 1IndicatorLea rnj_Code--ButtonOperating One Door Operator:• To move the garage door:- Enter your PIN.- PressC@.NOTEe If the door does not move, check the red LED onKeypad. If the LED is blinking rapidly, the PIN wasentered incorrectly. After the LEDstops blinking,re-enter your PIN and try again.Any keypad button will control the door for30 seconds after the door starts moving.Rapid Blinking of the red LEDindicates an error.After a few seconds the LEDwill turn off. Start over.A Set Wireless Keypad PIN (Personal ID Number):Activate programming mode.- Press(in order) )).- Red LEDblinks - once per second.• Enter your PIN (3 to 8 characters).• Press )).- Red LEDblinks- twice per second and turns off.B Programming the Keypad for Multiple Door openers:• Enter your PIN and press }.- Red LEDblinks - once per second.• Press again.- Red LEDblinks - twice per second.• Pressthe number of doors (total) you wishto control (@ or @).• Press ).- Red LEDblinks several times and turns off.C Programming Door Openers:Decide which door will be door #1, #2 and #3.Pressthe Learn Code Button (see Figure 1).- Learn Code Indicator LED(on Opener) blinks.• Enter your PIN and press _.- Learn Code Indicator LEDstays on.Pressthe number you have picked for thisdoor Opener(@ or @ or @).- Learn Code Indicator LEDstays on." Press _.- Learn Code Indicator LEDturns off,B Repeat step A above for each door opener,Eachdoor opener must be programmed to receive thesignal from the Wireless Keypad, oi _ ;5 0