Genie GCL OPGSX Series Installation Manual
                                                                    | |
Contents
| 
6.71) Press SET/CLEAR key to toggle to “ODC STB > ON”.2) Press SCROLL UP until display reads “OPEN MODE > C-STOP”.3) Press CAL/RUN to return to run mode.Monitored Reversing DevicesOPENCLOSESTOPCALRUN SCROLLSCROLLSETCLEARODC STB ONFigure 16NOTE: STB photocells should NOT be used on the Fire Door Operator. Use only Monitored Safety Edges listed:1). MillerEdge ME and MT series monitored edge sensors used in combination with MillerEdge InterfaceModule OPAKMEIX.S. (Direct connect through STB inputs.)2). MillerEdge Wireless monitored edge sensor OPAKMMWE.S.Section 6: Operator Setup Procedure |
Related manuals for Genie GCL OPGSX Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine