Genie GS-2668 RT Operators Manual With Maintenance Information

Also see for GS-2668 RT: Specifications Service manual Operator's manual Operators manual with maintenance information Operator's manual

Contents

Genie GS-2668 RT Operators Manual With Maintenance Information Manual pdf 19 page image

Part No. 82233 Genie GS-2668 RT & Genie GS-3268 RT 17Operator's ManualSecond Edition · Third Printing1 Select a test area that is firm, level and free ofobstruction.At the Ground Controls2 Pull out the platform and ground red EmergencyStop button to the on position.3 Turn the key switch to ground control.4 Observe the diagnosticLED readout.Result: LED should looklike picture at right.5 Start the engine. SeeOperating Instructionssection.Test Emergency Stop6 Push in the ground red Emergency Stop buttonto the off position.Result: The engine should turn off and nofunctions should operate.7 Pull out the red Emergency Stop button tothe on position and restart the engine.Test the Up/Down FunctionsThe audible warnings on this machine and thestandard horn all come from the same centralalarm. The horn is a constant tone. The descentalarm sounds at 60 beeps per minute. The alarmthat goes off when the machine is not level soundsat 180 beeps per minute.8 Do not push and hold the function enable buttonand activate the platform up function.Result: No function should operate.Function TestsDo Not Operate Unless:You learn and practice the principles of safemachine operation contained in this operator'smanual.1 Avoid hazardous situations.2 Always perform a pre-operationinspection.3 Always perform function tests prior touse.Know and understand the function testsbefore going on to the next section.4 Inspect the workplace.5 Only use the machine as it was intended.FundamentalsThe function tests are designed to discover anymalfunctions before the machine is put into service.The operator must follow the step-by-stepinstructions to test all machine functions.A malfunctioning machine must never be used. Ifmalfunctions are discovered, the machine must betagged and removed from service. Repairs to themachine may only be made by a qualified servicetechnician, according to the manufacturer'sspecifications.After repairs are completed, the operator mustperform a pre-operation inspection and functiontests again before putting the machine into service.