Genie GSMSOC Series User Manual
                 | |
Contents
|
CHAPTER 2 QUICK START 13CHAPTER 2 QUICK START122.1 INSTALLING THE SIM CARD AND TEMPERATURE SENSOR1. The power switch should be in the “OFF” position (See 7 on Figure 1)(please make sure the power socket is off before inserting the SIM Card)2. Open the socket’s SIM cover, you will see a SIM card holder (See 8 onFigure 1)3. Slide the metallic cover of the holder in the direction of “OPEN”, then liftthe metallic cover up and towards you4. Put the SIM card with the gold contacts face down and the slight cornercut out of the SIM at the bottom left5. Slide back the metallic cover in the direction of “LOCK” and make surethe SIM card locks into place6. The SIM card will be fixed in the holder7. Insert the temperature sensor into the I/O port (see 3 Figure 1)2.2 TURNING THE SOCKET ON/OFF1. Turn the power switch to “ON” position (see 7 on Figure 1)2. Plug the GSM power socket into a UK 13 Amp / Schuko socket3. The “Green” power light will illuminate and the “Blue” GSM light will flashfor about 20 seconds before staying on constantly to confirm GSM signalis available (PLEASE MAKE SURE THE SIGNAL IN THE AREA IS GOOD)4. The socket is now ready to be programmed for remote useNote: The unit can be turned off by the switch (see 7 Figure 1) when not required fora period of time.CHAPTER 2 QUICK START2.1 INSTALL THE SIM CARD AND TEMPERATURE SENSOR2.2 TURNING THE SOCKET ON/OFF2.3 USER AUTHORISATION LEVEL2.4 SETTING THE MASTER NUMBER2.5 SETTING THE DATE/TIME (GMT)2.6 CONTROLLING THE OUTPUT/POWER2.7 NOTIFICATION OF POWER SUPPLY LOSS |
Related manuals for Genie GSMSOC Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine