Genie GSMSOC Series User Manual
                 | |
Contents
|
CHAPTER 2 QUICK START 15CHAPTER 2 QUICK START142.5 SETTING THE DATE/TIME (GMT)Important noteIf the power socket is being used for the first time, or it has been reset, themaster user must set the socket time according to the current time of theSMS centre. If the time is not set the power socket will use the original pre-set start date / time from 00:00:00 1st June 2004.Please send the following command to set the time: #152#Successful SMS replyThe time of the device has been regulated automatically **********2.6 CONTROLLING THE OUTPUT/POWERMethod 1(Master) Please send the following command to turn the power socketoutput ‘ON’: #01#(Additional User) Please send the following command to turn the powersocket output ‘ON’: #01#password#(Master) Please send the following command to turn the power socketoutput ‘OFF’: #02#(Additional User) Please send the following command to turn the powersocket output ‘OFF’: #02#password#Successful SMS replyThe socket power output has been switched onThe socket power output has been switched offMethod 2Press the M button (See 3 on Figure 1) on the side of the socket for ½ asecond until the output light goes on/off and then again to turn the outputback on/off2.3 USER AUTHORISATION LEVELAll settings can be adjusted via SMS command’s. The GSM power sockethas two levels of control.Master User:Only the master user has authorisation to use all the features of the GSMpower socket.Only one master number can be programmed per socket. The masternumber can be changed to another number by sending an SMS command.Additional users:Four additional users have authorisation to use two commands to switchon or cut off the socket output.The other mobile phone users have no authorisation to use the GSM powersocket.If there are any changes made to the GSM power socket the master useralways gets the notifications.2.4 SETTING THE MASTER NUMBERThe user must send the following SMS to the socket from their mobilephone, they will then become the master.Please send the following command to add a master number: #00#Successful SMS replyWelcome to the GSM socket. Your password is 1234Failed SMS replyIf a user tries to add another master user, the GSM power socket will sendan SMS stating “The master user already exists”, to change the masternumber please refer to Chapter 3.1.4.Please note unless otherwise stated SMS commands to the socketcan only be sent by the master user. |
Related manuals for Genie GSMSOC Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine