Genie PowerMax 1200 Operation & Maintenance Manual

Also see for CB 1000: Programming, operation & maintenance manual Maintenance manual Operation & maintenance manual Operation & maintenance manual

Genie PowerMax 1200 Operation & Maintenance Manual Manual pdf 8 page image

R quired Pr rammingRequired Programming3MODEL AC SR3 THE GENIE COMPANYFCC ID: B8Q AC SR3 Residential Door OperatorIC: 2 33A-CS 1D 120V. 60HZ. 5AS/N:10XXXX XXXXXXXSTB BWC IWCNOTUSED NOTUSEDNOTUSED NOTUSEDFROM STBsFROM WALLCONSOLESTB BWC IWCFROM STBsFROM WALLOM STBCONSOLEB/W WOpen/Close ButtonOpens and closes door from inside garage.Sure-Lock™ Button– LOCK disables controlsafter door is completelyclosed.– UNLOCK allows controls towork normally.Indicator Light–Red indicator light isalways ON.–When Sure-Lock™ is ON,the indicator light flashes.Independent Light Control ButtonControls door opener lights from inside garage.To powerheadTo powerheadB/W WOpen/Close ButtonOpens and closes door from inside garage.Sure-Lock™ Button– LOCK disables controls afterdoor is completely closed.– UNLOCK allows controls towork normally.Indicator Light–Red indicator backlight is ON.–When Sure-Lock™ isON, the indicator light is OFFIndependent Light Control ButtonControls door opener lights from inside garage.To powerheadTo powerheadWALL CONSOLE / OverviewThis opener has a serialnumber sticker in whichthe serial numbers beginwith 10 or higher.Wall consoles from other manufacturers may not work with openersof these serial number groups. Use only the wall console provided withthis unit. Each wall console has three buttons.In your carton you will find one of the followingwall consoles:Series II Wall Consoles with White ButtonsIndicator LightLarge white button will display Red when wall console is properlywired and Sure-Lock™ is OFF. When Sure-Lock™ is ON, this light is offOpen/Close ButtonUse this button to open or close garage door. When Sure-Lock™ isON, the Open/Close button will CLOSE the door only.NOTE: Constant button pressure in the CLOSE mode will overrideSTB fault in the powerhead and close door.Independent Light Control ButtonUse this button to turn powerhead lights ON. Powerhead lighting willremain ON until this button is pressed again or a door action has beencompleted.NOTE: If opener has a Motion Detector sensor, it will keep powerheadlights ON as long as motion is detected.Sure-Lock™ ButtonWhen Sure-Lock™ is ON, the powerhead cannot be activated by thewall console or a remote.• Press and release (or until red light goes off) to activate Sure-Lock™.• Press and release to turn Sure-Lock™ OFF.Series III Wall Consoles with Black ButtonsIndicator LightIndicator light will display Red when wall console is properly wired andSure-Lock™ is OFF. When Sure-Lock™ is ON, indicator light flashes.Open/Close ButtonUse this button to open or close garage door. When Sure-Lock™ isON, the Open/Close button will CLOSE the door only.NOTE: Constant button pressure in the CLOSE mode will override STBfault in the powerhead and close door.Independent Light Control ButtonUse this button to turn powerhead lights ON. Powerhead lighting willremain ON until this button is pressed again or a door action has beencompleted.NOTE: If opener has a Motion Detector sensor, it will keep powerheadlights ON as long as motion is detected.Sure-Lock™ ButtonWhen Sure-Lock™ is ON, the powerhead cannot be activated by thewall console or a remote.• Press and hold for 5 seconds (or until Indicator Light flashes) toactivate Sure-Lock™.• Press and release to turn Sure-Lock™ OFF.TIP8G999-393 Manual-ScrewBeltChain-EN indd 8 7/13/12 10 17 AM