Part No. 102916 S-100 • S-105 • S-120 • S-125 4 - 1June 2011 Section 4 • Repair ProceduresREV A Repair ProceduresAbout This SectionMost of the procedures in this section should onlybe performed by a trained service professionalin a suitably equipped workshop. Select theappropriate repair procedure after troubleshootingthe problem.Perform disassembly procedures to the pointwhere repairs can be completed. Then tore-assemble, perform the disassembly steps inreverse order.Symbols LegendSafety alert symbol—used to alertpersonnel to potential personalinjury hazards. Obey all safetymessages that follow this symbolto avoid possible injury or death.Used to indicate the presence ofan imminently hazardous situationwhich, if not avoided, will result indeath or serious injury.Used to indicate the presence of apotentially hazardous situationwhich, if not avoided, could resultin death or serious injury.With safety alert symbol—used toindicate the presence of apotentially hazardous situationwhich, if not avoided, may causeminor or moderate injury.Used to indicate the presence of apotentially hazardous situationwhich, if not avoided, may result inproperty damage.Indicates that a specific result is expected afterperforming a series of steps.Indicates that an incorrect result has occurredafter performing a series of steps.Observe and Obey:Repair procedures shall be completed by aperson trained and qualified on the repair of thismachine.Immediately tag and remove from service adamaged or malfunctioning machine.Repair any machine damage or malfunctionbefore operating the machine.Before Repairs Start:Read, understand and obey the safety rulesand operating instructions in theGenie S-100 &Genie S-105 Operator’s Manual and theGenie S-120 & Genie S-125 Operator’s Manual.Be sure that all necessary tools and parts areavailable and ready for use.Read each procedure completely and adhereto the instructions. Attempting shortcuts mayproduce hazardous conditions.Use only Genie approved replacement parts.Unless otherwise specified, perform eachrepair procedure with the machine in thefollowing configuration:· Machine parked on a firm, level surface· Boom in the stowed position· Turntable rotated with the boom betweenthe circle-end wheels· Turntable secured with the turntablerotation lock pin· Key switch in the OFF position with thekey removed· Wheels chocked· All external AC power supply disconnectedfrom the machine123456789012345123456789012345123456789012345123456789012345123456789012345123456789012345123456789012345
