Section 3 • Scheduled Maintenance ProceduresPart No. 102916 S-100 • S-105 • S-120 • S-125 3 - 17June 2011REV E10 Check the ambient air temperature and adjustthe specific gravity reading for each cell asfollows:• Add 0.004 to the reading of each cell forevery 10° / 5.5° C above 80° F / 26.7° C.• Subtract 0.004 from the reading of each cell forevery 10° / 5.5° C below 80° F / 26.7° C.Result: All battery cells display a specificgravity of 1.277 +/- 0.007. The battery is fullycharged. Proceed to step 11.Result: One or more battery cells display aspecific gravity from 1.269 to 1.218. The batteryis still useable, but at a lower performance sowill need to be recharged more often. Proceedto step 11.Result: One or more battery cells display aspecific gravity from 1.217 to 1.173. The batteryis approaching the end of its life. Proceed tostep 11.Result: The difference in specific gravityreadings between cells is greater than 0.1 ORthe specific gravity of one or more cells is 1.172or less. Replace the battery.11 Check the battery acid level. If needed,replenish with distilled water to 1/ 8 inch / 3 mmbelow the bottom of the battery fill tube. Do notoverfill.12 Install the vent caps and neutralize anyelectrolyte that may have spilled.B-2Inspect the Electrical WiringGenie requires that this procedure be performedevery 250 hours or quarterly, whichever comesfirst.Maintaining electrical wiring in good condition isessential to safe operation and good machineperformance. Failure to find and replace burnt,chafed, corroded or pinched wires could result inunsafe operating conditions and may causecomponent damage.Electrocution/burn hazard. Contactwith hot or live circuits could resultin death or serious injury. Removeall rings, watches and otherjewelry.1 Open the engine side turntable cover.2 Remove the engine pivot plate retainingfastener. Swing the engine pivot plate out awayfrom the machine.a engine pivot plate anchor holeb engine pivot plate retaining fastener3 Locate the engine pivot plate anchor hole at thepivot end of the engine pivot plate.CHECKLIST B PROCEDURES
