Section 4 • Repair ProceduresPart No. 826364 S-40 • S-45 • S-40 TRAX • S-45 TRAX 4 - 1February 2014Repair ProceduresAbout This SectionMost of the procedures in this section should onlybe performed by a trained service professionalin a suitably equipped workshop. Select theappropriate repair procedure after troubleshootingthe problem.Perform disassembly procedures to the point whererepairs can be completed. To re-assemble, performthe disassembly steps in reverse order.Symbols LegendSafety alert symbol—used to alertpersonnel to potential personalinjury hazards. Obey all safetymessages that follow this symbolto avoid possible injury or death.Indicates an imminently hazardoussituation which, if not avoided, willresult in death or serious injury.Indicates a potentially hazardoussituation which, if not avoided,could result in death or seriousinjury.Indicates a potentially hazardoussituation which, if not avoided,may cause minor or moderateinjury.Indicates a potentially hazardoussituation which, if not avoided,may result in property damage.Indicates that a specific result is expected afterperforming a series of steps.Indicates that an incorrect result has occurredafter performing a series of steps.Observe and Obey:Repair procedures shall be completed by aperson trained and qualified on the repair of thismachine.Immediately tag and remove from service adamaged or malfunctioning machine.Repair any machine damage or malfunctionbefore operating the machine.Before Repairs Start:Read, understand and obey the safety rules andoperating instructions in the appropriateOperator's Manual on your machine.Be sure that all necessary tools and parts areavailable and ready for use.Use only Genie approved replacement parts.Read each procedure completely and adhereto the instructions. Attempting shortcuts mayproduce hazardous conditions.Unless otherwise specified, perform eachrepair procedure with the machine in thefollowing configuration:• Machine parked on a firm, level surface• Boom in stowed position• Turntable rotated with the boom betweenthe non-steer wheels• Turntable secured with the turntablerotation lock• Key switch in the off position with thekey removed• Wheels chocked• All external AC power disconnectedfrom the machine
