Genie SILENTMAX 1000 3042 Operation And Maintenance Manual

Contents

Genie SILENTMAX 1000 3042 Operation And Maintenance Manual Manual pdf 10 page image

©2011 The Genie Company 3/201110PROGRAMSET—+PROGRAMSET—+PRESS and HOLDSEE BOTHBlue LEDscome ONSEE oneBlue LEDcome ONPRESS and release a previously programmedGenie® IntelliCode® 2 remote button onremote. If you are unsure which remote youhave see page 16. Remote must be IntelliCode®2 enabled.RELEASE1 2 3 4OPTIONAL PROGRAMMING POWERHEAD TOHomelink®, Car2U®, or IntelliCode® 1 REMOTES and IntelliCode® 1 WIRELESS KEYPADSTo complete any of these tasks you MUST have at least one Genie® IntelliCode® 2 remotebutton already programmed to the powerhead present.For Homelink® or Car2U®: You must also have your Homelink® or Car2U® enabled vehiclepresent and their programming instructions to perform these programming steps.For Genie® IntelliCode® 1 remote: You must also have your Genie® IntelliCode® 1 remotepresent.For Genie® IntelliCode® 1 wireless keypad: You must also have your Genie® wirelesskeypad installed and a PIN already programmed into the keypad. Programming instructionsfor Genie® IntelliCode® 2 wireless keypad will come with the wireless keypad.PRESS andRELEASE5 On the IntelliCode® 1 remotePRESS a button and RELEASE. SEElong LED come ON Purple.6IntelliCode® 1 remote or wireless keypad programming7On the IntelliCode® 1 remotePRESS the same button andRELEASE.SEE both LEDs on the powerheadcome ON Blue. The next press ofthe remote will operate door.Test. Repeat as necessary for anyother IntelliCode® 1 remotes.Genie® IntelliCode® 1 remote Genie® IntelliCode® 1 wireless keypadSEE long PurpleLED flashingSEE both LEDsflash PurpleAll optional programming is complete. Your garage door opener is ready to use.5 For Car2U® enabled vehicles follow the Car2U®instructions.6 Test. Repeat as necessary for any other Car2U®enabled vehicle.Homelink® programmingIf your Homelink® has been previously programmed to anGenie® opener begin with Step 1 and continue through Step5 and 6 of the Homelink® section below.If your Homelink® has not yet been linked to a Genie®opener then go to page 16 and change one remote buttonfrom IntelliCode® 2 to IntelliCode® 1, then programthat button with the car Homelink® using Homelink®instructions and repeat steps 1-4 then continue withHomelink® steps 5-6.56PRESS the Homelink® button twice.Test. Repeat as necessary for any other pre-programmed Homelink® enabled vehicle.5 Enter your wireless keypad PIN.6 Press and hold button 1 secondthen release and see on powerheadlong LED come ON Purple.7 Press and hold button 1second again then release and see onpowerhead both LEDs flash Blue.8 Press and hold button again andopener will activate9 Wait 30 seconds, enter pin and pressbutton to verify operation.Homelink® or Car2U® programming