REV BJune 2005 Section 4 • Repair ProceduresPart No. 65162 TMZ-50/30 4 - 7113-1Outrigger ComponentsHow toRemove an OutriggerOutriggers are essential to safe machine operationand machine stability. Operating a machine with adamaged or improperly operating outrigger willresult in death or serious injury.1 Lower the outrigger to be removed just until ittouches the ground. Do not rest the entireweight of the outrigger on the ground.Outriggers at the Platform end:2 Tag and disconnect the electrical wiring at thetail light.3 Remove the tail light mounting fasteners.Remove the tail light from the machine.All outriggers:4 Remove the outrigger limit switch mountingfasteners at the foot pad. Do not disconnect thewiring.5 Remove the limit switch and cable assemblyfrom the chassis end of the outrigger.6 Remove the pin retaining fasteners from theoutrigger pivot pin.7 Attach a lifting strap of suitable capacity from anoverhead crane to the pivot end of theoutrigger.8 Place a 2 x 4 x 10 inch / 5 x 10 x 25 cm woodenblock between the outrigger cylinder rod andthe outrigger mounting arm.9 Remove the pin retaining fasteners from theoutrigger cylinder rod-end pivot pin.10 Use a soft metal drift pin to remove the rod-endpivot pin. Rest the cylinder on the block.11 Use a soft metal drift pin to remove theoutrigger pivot pin.Crushing hazard. The outriggermay fall when the outrigger pivotpin is removed if it is not properlysupported.12 Remove the outrigger from the machine.Outriggers800-610-4101ActionRental.com
