REV BJune 2005Section 3 • Scheduled Maintenance Procedures3 - 12 TMZ-50/30 Part No. 65162CHECKLIST A PROCEDURESA-13Grease the Turntable RotationBearing and Rotate GearGenie specifications require thatthis procedure be performed every100 hours of operation.Regular application of lubrication to the turntablebearing and rotate gear is essential to goodmachine performance and service life. Continueduse of an insufficiently greased bearing and gearwill result in component damage.1 Locate the grease fitting on the inside of theturntable rotation bearing.The grease fitting is best locatedthrough the bulkhead openingbehind the function manifold.A-14Perform Engine Maintenance -Honda Models (if equipped)Engine specifications requirethat this procedure be performedevery 100 hours or semi-annually,whichever comes first. Performthis procedure more often if dustyconditions exist.Proper engine maintenance, following the enginemanufacturer's maintenance schedule, is essentialto good engine performance and service life.Failure to perform the maintenance procedurescan lead to poor engine performance andcomponent damage.Required maintenance procedures and additionalengine information is available in the HondaGX340 Engine Owner Manual(Honda part number 31ZH9603).Honda GX340 Owner's ManualGenie part number 97361a zerk fittingb rotate bearing2 Pump grease into the turntable rotation bearing.Rotate the turntable in increments of 4 to 5inches / 10 to 13 cm at a time and repeat thisstep until the entire bearing has been greased.3 Apply grease to each tooth of the drive gearlocated under the turntable.Grease SpecificationChevron Ultra-duty grease, EP NLGI 2 (lithium based)or equivalentab800-610-4101ActionRental.com
