Regulatory Information B-7On the Use of the RF DeviceNOTE: The information in this section applies to models with the wireless LANmodule.USA and Canada Safety Requirements and NoticesIMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, theantenna used for this transmitter must be installed to provide a separation distanceof at least 20 cm from all persons and must not be co-located or operating inconjunction with any other antenna or transmitter.Radio Frequency Interference Requirements and SARThe FCC with its action in ET Docket 93-62 has adopted a safety standard forhuman exposure to Radio Frequency (RF) electromagnetic energy emitted by FCCcertified equipment. The wireless LAN module meets the Human Exposure limits foundin OET Bulletin 65, 2001, and ANSI/IEEE C95.1, 1992. Proper operation of thisradio according to the instructions found in this manual will result in exposuresubstantially below the FCC’s recommended limits. The following safety precautionsshould be observed: Do not touch or move antenna while the unit is transmitting or receiving. Do not hold any component containing the radio such that the antenna is veryclose or touching any exposed parts of the body, especially the face or eyes,while transmitting. Do not operate the radio or attempt to transmit data unless the antenna isconnected; if not, the radio may be damaged.Use in specific environments: The use of wireless devices in hazardous locations is limited by the constraintsposed by the safety directors of such environments.
