H.264 DVR User Manual
                                                                                                             | |
Contents
| 
Digital Video Recorder User Manual757.1.2 On WANThere are two ways that the DVR is connected to internet.1. Connect the DVR to internet through a router or virtual server.Step1: Input IP address, Subnet, Gateway. If using DHCP, please enable DHCP in both the DVR and router.Step2: Enter Video to set network video parameters like resolution, frame rate etc.Step3: Forward IP address and port number in Virtual Server setup of the router or virtual server. Close firewall.Notice: Forwarding block may be different in different routers and server, please check your router manual.If users want to utilize dynamic domain name, need apply for a domain name in a DDNS server supported by the DVR or router. Then add to theDVR or router.Now this unit only supportswww.dns2p.com ， www.88IP.net ，www.meibu.com ，www.dyndns.com，andwww,no-ip.comAbout the router, please check in the router manual.Step5: Open IE browser, input IP address, or dynamic domain name and enter. If HTTP port is not 80, add the port number after IP address ordomain name.Step6: IE will download ActiveX automatically. Then a window pops up and asks for user name and password.Step7: Input name and password correctly, and enter to view.Notice: If you cannot download and install ActiveX, please refer to Appendix A FAQ Q7.2. Connect the DVR to internet directly.Step1: Input IP address, Subnet, Gateway gotten from your ISP. If using ADSL, please input user name and password, and click OK. The DVRwill connect the server and show “connection succeeds”.Step2: The following steps are the same as STEP4-7 of the connection way above. |
Related manuals for H.264 DVR
manualsdatabase
Your AI-powered manual search engine