4-41) The LEDs on the front panel show that the router is operating normally.2) The console terminal displays normally.For local configuration, after you power on the router, you can see the startup banner. See section257260720 “Startup Process”.3) After completing the power-on self-test (POST), the system asks you to press . When theprompt appears, you may proceed to configure the router.Startup ProcessDuring the power-on or reboot process, the router first initializes its memory:InitDDRThen the router runs BootROM, and the console terminal displays the following information:system start booting......Version 2.11Press CTRL+D to stop auto-bootPress and the system will enter the basic BootROM segment menu; otherwise, the system willenter the decompression process of the extended BootROM segment.Enter within 3 seconds after the “Press CTRL+D to stop auto-boot” appears, the system canenter basic BootROM segment menu; otherwise, the system will enter the decompression process ofthe extended BootROM segment.Booting Normal Extended BootRomDecompressing...done!Ensure the baudrate is set to 9600bps!Starting at 0xa00000...******************************************************** ** MSR30-20 BOOTROM, Version 2.11 ** ********************************************************Copyright(c) 2004-2007Compiled date: Apr 09 2007, 08:52:28CPU type : MPC8349ECPU L1 Cache : 32KBCPU Clock Speed : 533MHzMemory Type : DDR SDRAMMemory Size : 256MBMemory Speed : 266MHzBootRom Size : 4096KBCPLD Version is 1.00