H3C S3600-28P-SI Operation Manual

Also see for H3C S3600 Series: Datasheet Installation manual Command manual Operation manual Operation manual

Contents

H3C S3600-28P-SI Operation Manual Manual pdf 5 page image

Operation Manual – Port Basic ConfigurationH3C S3600 Series Ethernet Switches-Release 1510 Chapter 1 Port Basic Configuration1-4Note:The access ports or hybrid ports must be added to an existing VLAN.1.2 Ethernet Port Configuration1.2.1 Initially Configuring a PortTable 1-3 Initially configure a portOperation Command RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Enable the Ethernet port undo shutdownOptionalBy default, the port isenabled.Use the shutdowncommand to disable theport.Set the description of theEthernet port description textOptionalBy default, no descriptionis defined for the port.Set the duplex mode ofthe Ethernet port duplex { auto | full | half }OptionalBy default, the duplexmode of the port is auto(auto-negotiation).Set the speed of theEthernet portspeed { 10 | 100 | 1000 |auto }OptionalBy default, the speed ofthe port is auto(auto-negotiation).Set the mediumdependent interface(MDI) attribute of theEthernet portmdi { across | auto |normal }OptionalBe default, the MDIattribute of the port isauto.Allow jumbo frames thatare not larger than 9216bytes to pass through theEthernet portjumboframe enableOptionalBy default, jumbo framesthat are not larger than9216 bytes are allowed topass through the port.