H3C S3600 Series Operation Manual

Also see for H3C S3600 Series: Datasheet Installation manual Command manual Operation manual Operation manual

Contents

H3C S3600 Series Operation Manual Manual pdf 14 page image

Operation Manual – System Maintenance and DebuggingH3C S3600 Series Ethernet Switches-Release 1510Chapter 1 BootROM and Host SoftwareLoading1-12Enter your choice(0-3):Enter 2 in the above menu to download the host software using FTP.The subsequent steps are the same as those for loading the BootROM, except for thatthe system gives the prompt for host software loading instead of BootROM loading.Caution:When loading BootROM and host software using FTP through BOOT menu, you arerecommended to use the PC directly connected to the device as FTP server to promoteupgrading reliability.1.3 Remote BootROM and Software LoadingIf your terminal is not directly connected to the switch, you can telnet to the switch, anduse FTP or TFTP to load BootROM and host software remotely.1.3.1 Remote Loading Using FTPI. Loading Procedure Using FTP Client1) Loading BootROMAs shown in Figure 1-8, a PC is used as both the configuration device and the FTPserver. You can telnet to the switch, and then execute the FTP commands to downloadthe BootROM program S3600.btm from the remote FTP server (whose IP address is10.1.1.1) to the switch.FTP clientSwitchPCEthernet portFTP1server0.1.1.1InternetInternetFTP clientSwitchPCEthernet portFTP1server0.1.1.1InternetInternetFigure 1-8 Remote loading using FTP ClientStep 1: Download the program to the switch using FTP commands.