7• If you execute the command in port group view, the configuration takes effect on all ports in the portgroup.To configure jumbo frame support in interface view or port group view:Step Command Remarks1. Enter system view. system-view N/A2. Enter Ethernetinterface view.interface interface-typeinterface-number N/A3. Configure jumboframe support. jumboframe enable [ value ]By default, the switch allows jumbo frames within10000 bytes to pass through Ethernet interfaces.If you set the value argument multiple times, thelatest configuration takes effect.Enabling the auto power-down function on an EthernetinterfaceTo save power, enable the auto power-down function on Ethernet interfaces. An interface enters thepower save mode if it has not received any packet for a certain period of time (this interval depends onthe specifications of the chip, and is not configurable). When a packet arrives later, the interface entersits normal state.To enable auto power-down on an Ethernet interface:Step Command Remarks1. Enter system view. system-view N/A2. Enter Ethernetinterface view.interface interface-typeinterface-number N/A3. Enable autopower-down on anEthernet interface.port auto-power-down Disabled by default.NOTE:When you connect an interface enabled with auto power-down to a device, if the link cannot go upcorrectly, disable auto power-down on the interface and try again.Configuring a Layer 2 Ethernet interfaceLayer 2 Ethernet interface configuration task listTask RemarksConfiguring a port group OptionalApplicable to Layer 2 Ethernet interfaces