48Step Command Remarks2. Enter aggregate interface view.• Enter Layer 2 aggregate interfaceview:interface bridge-aggregationinterface-number• Enter Layer 3 aggregate interfaceview:interface route-aggregationinterface-numberUse either command.3. Restore the default settings for theaggregate interface . default N/AConfiguring load sharing for link aggregationgroupsConfiguring load-sharing criteria for link aggregation groupsYou can determine how traffic is load-shared in a link aggregation group by configuring load-sharingcriteria. The criteria can be source/destination MAC addresses, source/destination service port numbers,ingress ports, source/destination IP addresses, or any combination. You can also let the systemautomatically choose link-aggregation load-sharing criteria based on packet types (Layer 2, IPv4, or IPv6,for example).You can configure global or group-specific load-sharing criteria. A link aggregation group preferentiallyuses the group-specific load-sharing criteria. If no group-specific load-sharing criteria are available, thegroup uses the global load-sharing criteria.NOTE:The load sharing criteria configuration applies to only unicast packets, and can change the load sharingcriteria for unicast packets. Broadcast packets and multicast packets always use the default load sharingcriteria.Configuring the global link-aggregation load-sharing criteriaStep Command Remarks1. Enter systemview. system-view N/A2. Configure thegloballink-aggregationload-sharingcriteria.link-aggregation load-sharingmode { destination-ip |destination-mac | destination-port| ingress-port | source-ip |source-mac | source-port } *By default, the system selects the global loadsharing criteria according to the packet type.In system view, the switch supports the following load-sharing criteria and combinations:• Load-sharing criteria automatically determined based on the packet type• Source IP address