215Step Command Remarks11. Associate the class with thebehavior.classifier tcl-name behaviorbehavior-nameRepeat this step to create otherclass-behavior associations.Configuring the customer-side portStep Command Remarks1. Enter system view. system-view N/A2. Enter interface view or portgroup view.• Enter Layer 2 Ethernet interfaceview:interface interface-typeinterface-number• Enter port group view:port-group manualport-group-nameN/A3. Configure the link type of theport.• Configure the port as a trunkport:port link-type trunk• Configure the port as a hybridport:port link-type hybridUse one of the commands.The default link type of an Ethernetport is access.4. Assign the port to all SVLANs.• Assign the trunk port to VLANs:port trunk permit vlan { vlan-list| all }• Assign the hybrid port to VLANsas a tagged member:port hybrid vlan vlan-listtaggedUse one of the commands.By default:• A trunk port is assigned only toVLAN 1.• A hybrid port is an untaggedmember of VLAN 1.5. Apply the uplink policyconfigured for thecustomer-side port toincoming traffic.qos apply policy policy-nameinbound N/A6. Apply the downlink policyconfigured for thecustomer-side port to outgoingtraffic.qos apply policy policy-nameoutbound N/AConfiguring the network-side portStep Command Remarks1. Enter system view. system-view N/A2. Enter interface view or portgroup view.• Enter Layer 2 Ethernet interfaceview:interface interface-typeinterface-number• Enter port group view:port-group manualport-group-nameN/A
