H3C S5120-EI Series Installation Manual

Also see for S5120-EI Series: Configuration guide Configuration guide Configuration guide Operation manual Configuration guide

H3C S5120-EI Series Installation Manual Manual pdf 57 page image

4-2RJ-45 Signal Direction DB-93 TXD ← 34 CD → 15 GND -- 56 RXD → 27 DSR → 68 CTS → 8Connection ProcedureWhen you want to use the terminal to configure the switch, follow these steps to connect a terminaldevice to the switch using the console cable:Step1 Plug the DB-9 female connector of the console cable to the serial port of the console terminal or PC.Step2 Connect the RJ-45 connector of the console cable to the console port of the switch.Pay attention to the mark on the console port and be sure to plug the connector to the correct port.z When connecting a PC to a powered-on switch, you are recommended to connect the DB-9connector of the console cable to the PC before connecting the RJ-45 connector to the switch.z When disconnecting a PC from a powered-on switch, you are recommended to disconnect theDB-9 connector of the console cable from the PC after disconnecting the RJ-45 connector from theswitch.Setting Terminal ParametersWhen setting up the configuration environment through the console port, the terminal or PC can use theterminal emulation program to communicate with the switch. You can run the HyperTerminal of theWindows operating system to connect to other PCs, network devices, and Telnet sites. For detailedinformation and the use of the HyperTerminal, refer to the HyperTerminal Help documentation in Helpand Support Center on the PC running the Windows operating system.In the following configuration procedure, Windows XP HyperTerminal is used to communicate with theswitch.1) Start the PC and run the terminal emulation program.2) Set terminal parameters as follows:z Bits per second: 9,600