H3C S5120-EI Series Installation Manual

Also see for S5120-EI Series: Configuration guide Configuration guide Configuration guide Operation manual Configuration guide

H3C S5120-EI Series Installation Manual Manual pdf 73 page image

5-86) Restore the download rate to the defaultSet the baud rate to 9600 bps (refer to Change the rate of the serial port on the terminal on page 5-4 fordetailed operation).7) Restart the switch to make the updated Boot ROM file effectivePress Enter in the HyperTerminal window to return to the Boot ROM update menu.BOOT MENU1. Download application file to flash2. Select application file to boot3. Display all files in flash4. Delete file from flash5. Modify bootrom password6. Enter bootrom upgrade menu7. Skip current configuration file8. Set bootrom password recovery9. Set switch startup mode0. RebootEnter your choice(0-9):Enter 0 to restart the device. After that, the updated Boot ROM file becomes effective.Loading host softwareStep 1: Select 1 in Boot Menu to load the host software of the switch. The system displays the followinginformation:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):3To load the host software through XMODEM, select 3.The subsequent steps are almost the same as those for loading the Boot ROM software, except that thesystem gives the prompt for host software loading instead of Boot ROM loading.Loading Software Using TFTP through Ethernet PortIntroduction to TFTPTrivial file transfer protocol (TFTP), a protocol in TCP/IP protocol suite, is used for trivial file transferbetween client and server. It uses UDP to provide unreliable data stream transfer service.