167Configured in Layer 2 aggregate interface view, this command takes effect on the Layer 2 aggregateinterface and the member ports in its aggregation group. You can configure this command on a Layer 2aggregate interface and its member ports separately. Configured on an aggregation member port, thiscommand takes effect immediately. For more information about link aggregation, see the Layer 2—LANSwitching Configuration Guide.Examples# Set the TPID value to 0x9100 on GigabitEthernet 1/0/1. system-view[Sysname] interface gigabitethernet 1/0/1[Sysname-GigabitEthernet1/0/1] qinq ethernet-type 9100# Set the TPID value to 0x9100 for all ports in port group 1. system-view[Sysname] port-group manual 1[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/1 to gigabitethernet1/0/6[Sysname-port-group-manual-1] qinq ethernet-type 9100qinq vidSyntaxqinq vid vlan-idundo qinq vid vlan-idViewLayer 2 ethernet interface view, Layer 2 aggregate interface view, port group viewDefault Level2: System levelParametersvlan-id: Outer VLAN ID, ranging from 1 to 4094.DescriptionUse the qinq vid command to enter QinQ view and configure the outer VLAN tag for the port to add.Use the undo qinq vid command to remove all configurations corresponding to the outer VLAN IDperformed in QinQ view.By default, the outer VLAN tag is the port’s default VLAN tag.Configured in Ethernet interface view, this command takes effect on the current port only.Configured in port group view, this command takes effect on all ports in the port group.Configured in Layer 2 aggregate interface view, this command takes effect on the Layer 2 aggregateinterface and the member ports in its aggregation group. You can configure this command on a Layer 2aggregate interface and its member ports separately. Configured on an aggregation member port, thiscommand takes effect immediately. For more information about link aggregation, see the Layer 2—LANSwitching Configuration Guide.Related commands: raw-vlan-id inbound and qinq ethernet-type.
