5-138. Set bootrom password recovery9. Set switch startup mode0. RebootEnter your choice(0-9):Step7 Enter 0 to restart the device. After that, the updated Boot ROM file becomes effective.Loading host softwareSelect 1 in Boot Menu to load the host software of the switch. The system displays the followinginformation:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):2To load the host software through FTP, select 2.The procedure of loading an application file is similar to that of loading a Boot ROM file. The differencelies in that the system displays the prompt of loading the application file rather than the Boot ROM file.After loading the application file, the switch displays that you should configure the application attribute,that is, main, backup, or none. Type a specific attribute to complete loading the application file.Writing flash..................................................................................Done!Please input the file attribute (Main/Backup/None) MDone!If an application file with a specific attribute already exists when you set a new file with the attribute, theattribute of the existing file becomes none after the new file becomes effective.Loading Software Through CLIYou can telnet to the switch, and use FTP or TFTP to load Boot ROM and host software remotely.Loading Software Using FTPAs shown in Figure 5-8, a PC is used as both configuration device and FTP server. You can telnet to theswitch, and then execute the FTP commands to download the host program update.bin and the BootROM program update.btm from the remote FTP server (with IP address 202.10.10.53) to the switch.