H3C S5560X-EI Series Configuration Manual

Also see for S5560X-EI Series: Command reference Installation guide

Contents

H3C S5560X-EI Series Configuration Manual Manual pdf 25 page image

19[SwitchC-Tunnel3] source 3.3.3.3[SwitchC-Tunnel3] destination 2.2.2.2[SwitchC-Tunnel3] quit# Assign Tunnel 1 and Tunnel 3 to VXLAN 10.[SwitchC] vsi vpna[SwitchC-vsi-vpna] vxlan 10[SwitchC-vsi-vpna-vxlan-10] tunnel 1[SwitchC-vsi-vpna-vxlan-10] tunnel 3[SwitchC-vsi-vpna-vxlan-10] quit[SwitchC-vsi-vpna] quit# On GigabitEthernet 1/0/1, create Ethernet service instance 1000 to match VLAN 2.[SwitchC] interface gigabitethernet 1/0/1[SwitchC-GigabitEthernet1/0/1] port link-type trunk[SwitchC-GigabitEthernet1/0/1] port trunk permit vlan 2[SwitchC-GigabitEthernet1/0/1] service-instance 1000[SwitchC-GigabitEthernet1/0/1-srv1000] encapsulation s-vid 2# Map Ethernet service instance 1000 to VSI vpna.[SwitchC-GigabitEthernet1/0/1-srv1000] xconnect vsi vpna[SwitchC-GigabitEthernet1/0/1-srv1000] quit[SwitchC-GigabitEthernet1/0/1] quitVerifying the configuration1. Verify the VXLAN settings on the VTEPs. This example uses Switch A.# Verify that the VXLAN tunnel interfaces on the VTEP are up.[SwitchA] display interface tunnel 1Tunnel1Current state: UPLine protocol state: UPDescription: Tunnel1 InterfaceBandwidth: 64 kbpsMaximum transmission unit: 64000Internet protocol processing: DisabledLast clearing of counters: NeverTunnel source 1.1.1.1, destination 2.2.2.2Tunnel protocol/transport UDP_VXLAN/IPLast 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/secLast 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/secInput: 0 packets, 0 bytes, 0 dropsOutput: 0 packets, 0 bytes, 0 drops# Verify that the VXLAN tunnels have been assigned to the VXLAN.[SwitchA] display l2vpn vsi verboseVSI Name: vpnaVSI Index : 0VSI State : UpMTU : 1500Bandwidth : -Broadcast Restrain : -