43Gateway interface : VSI-interface 1VXLAN ID : 10Tunnels:Tunnel Name Link ID State Type Flood proxyTunnel2 0x5000002 Up Manual Disabled# Verify that Switch B has created ARP entries for the user terminals.[SwitchB] display arpType: S-Static D-Dynamic O-Openflow R-Rule M-Multiport I-InvalidIP address MAC address VID Interface/Link ID Aging Type12.1.1.4 0000-fc00-00ab 12 Vlan12 14 D25.1.1.5 4431-9234-24bb 20 Vlan20 17 D10.1.1.1 0000-fc00-00ab N/A Vsi1 17 D10.1.1.11 0000-fc00-00ab N/A Vsi1 20 D20.1.1.1 0000-fc00-00aa N/A Vsi3 17 D20.1.1.12 0000-fc00-00aa N/A Vsi3 20 D# Verify that Switch B has created FIB entries for the user terminals.[SwitchB] display fib 10.1.1.11Destination count: 1 FIB entry count: 1Flag:U:Useable G:Gateway H:Host B:Blackhole D:Dynamic S:StaticR:Relay F:FRRDestination/Mask Nexthop Flag OutInterface/Token Label10.1.1.11/32 10.1.1.11 UH Vsi1 Null[SwitchB] display fib 20.1.1.12Destination count: 1 FIB entry count: 1Flag:U:Useable G:Gateway H:Host B:Blackhole D:Dynamic S:StaticR:Relay F:FRRDestination/Mask Nexthop Flag OutInterface/Token Label20.1.1.12/32 20.1.1.12 UH Vsi1 Null3. Verify that the network connectivity for user terminals meets the requirements:# Verify that Terminal 1 and Terminal 3 can ping each other. (Details not shown.)# Verify that Terminal 1 and Terminal 3 can ping VLAN-interface 20 (25.1.1.5) on Switch E forWAN access. (Details not shown.)Distributed VXLAN IPv6 gateway configuration exampleNetwork requirementsAs shown in Figure 15:• Configure VXLAN 10 and VXLAN 20 as unicast-mode VXLANs on Switch A, Switch B, andSwitch C to provide connectivity for the user terminals across the network sites.• Manually establish VXLAN tunnels and assign the tunnels to the VXLANs.• Configure distributed VXLAN IP gateways on Switch A and Switch C to forward traffic betweenthe VXLANs.• Configure Switch B as a border gateway to forward traffic between the VXLANs and the WANconnected to Switch E.