4-43incremental-interval: LSA generation incremental interval in milliseconds, in the range 10 to 60000.The default is 5000 milliseconds.DescriptionUse the lsa-generation-interval command to configure the OSPF LSA generation interval.Use the undo lsa-generation-interval command to restore the default.The LSA generation interval defaults to 5 seconds.With this command configured, when network changes are not frequent, LSAs are generated at theinitial-interval. If network changes become frequent, LSA generation interval is incremented by aspecified value each time a generation happens, up to the maximum-interval.Related commands: lsa-arrival-interval.Examples# Configure the maximum LSA generation interval as 2 seconds, minimum interval as 100milliseconds and incremental interval as 100 milliseconds. system-view[Sysname] ospf 100[Sysname-ospf-100] lsa-generation-interval 2 100 100lsdb-overflow-limitSyntaxlsdb-overflow-limit numberundo lsdb-overflow-limitViewOSPF viewDefault Level2: System levelParametersnumber: Specifies the upper limit of external LSAs in the LSDB, in the range 1 to 1000000.DescriptionUse the lsdb-overflow-limit command to specify the upper limit of external LSAs in the LSDB.Use the undo lsdb-overflow-limit command to restore the default.External LSAs in the LSDB are not limited by default.Examples# Specify the upper limit of external LSAs as 400000. system-view[Sysname] ospf 100[Sysname-ospf-100] lsdb-overflow-limit 400000maximum load-balancing (OSPF view)Syntaxmaximum load-balancing maximum
