309display ospfv3 peerSyntaxdisplay ospfv3 [ process-id ] [ area area-id ] peer [ [ interface-type interface-number ] [ verbose ] |peer-router-id ] [ | { begin | exclude | include } regular-expression ]ViewAny viewDefault level1: Monitor levelParametersprocess-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.area: Specifies to display neighbor information of the specified area.area-id: The ID of an area, a decimal integer that is translated into IPv4 address format by the system (inthe range of 0 to 4294967295) or an IPv4 address.interface-type interface-number: interface type and number.verbose: Display detailed neighbor information.peer-router-id: Router-ID of the specified neighbor.|: Filters command output by specifying a regular expression. For more information about regularexpressions, see the Fundamentals Configuration Guide.begin: Displays the first line that matches the specified regular expression and all lines that follow.exclude: Displays all lines that do not match the specified regular expression.include: Displays all lines that match the specified regular expression.regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256 characters.DescriptionUse the display ospfv3 peer command to display OSPFv3 neighbor information.• If no area-id is specified, the neighbor information of all areas is displayed.• If no process-id is specified, the information of all processes is displayed.• If no interface or neighbor Router-ID is specified, the neighbor information of all interfaces isdisplayed.Examples# Display the neighbor information of OSPFv3 process 1 on an interface. display ospfv3 1 peer vlan-interface 10OSPFv3 Process (1)Neighbor ID Pri State Dead Time Interface Instance ID1.1.1.1 1 Full/ - 00:00:30 vlan10 0Table 67 Output descriptionField DescriptionNeighbor ID Router ID of a neighbor
