H3C S6300 Installation Manual
Also see for S6300 Series: Evb configuration guideTroubleshooting guideConfiguration ExamplesInstallation, quick startConfiguration guide
                                                           | |
Contents
| 
35Figure 38 Left side panel(1) Primary grounding point (2) Auxiliary grounding point 1S6300-42QTFigure 39 Front panel(1) 1/10GBase-T autosensing Ethernet port (2) 1/10GBase-T autosensing Ethernet port LED(3) SFP+ port (4) SFP+ port LED(5) QSFP+ port (6) QSFP+ port LED(7) System status LED (SYS)Figure 40 Rear panel(1) Grounding screw (auxiliary grounding point 2) (2) Management Ethernet port(3) Fan tray slot 1 (4) Fan tray slot 2(5) Power module slot 1 (6) Power module slot 2(7) Console port (8) LINK LED for the management Ethernet port(9) ACT LED for the management Ethernet port (10) USB portThe S6300-42QT switch comes with the power module slots empty and the filler modules for theslots as accessories. You can install one or two power modules for the switch as needed. In Figure40, two LSVM1AC650 power modules are installed. For more information about installing andremoving a power module, see "Installing/removing a power module."The S6300-42QT switch also comes with the fan tray slots empty. You must install two fan trays ofthe same model for the switch. In Figure 40, two LSWM1HFANSC fan trays are installed. For moreinformation about installing and removing a fan tray, see "Installing/removing a fan tray."1 2 3 4 5 6 7 |
Related manuals for H3C S6300 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine